Dec 26, 2019 · I have been trying to simulate a VCO for a CB radio on LTspice, but cannot get it to run. The ac analysis give me a peak at about 3.5 MHz but cannot get anything from the .trans. It is …

Nov 13, 2018 · I'm attaching an LTspice file that simulates a crystal oscillator with resonant frequency 1MHz, and it works fine. But if I change L1 from 2.5 H to 9.8 mH to simulate a crystal oscillator with …

May 22, 2019 · But how can i simulate those two signals on one same line ? A signal line cannot be at two different voltages at the same time. My circuit designs should be regarded as experimental. …

Feb 21, 2012 · You can simulate voltage and current of a charging/discharging capacitor using the transient analysis function. Go to Simulate-->Analyses-->Transient Analysis.

Jun 13, 2019 · Hello, I need to simulate a 3 phase star-delta (Yd11) transformer in LTspice. Any idea of how can I proceed? Thanking in anticipation.

Feb 17, 2013 · Hi, I wrote UART code that sends UART data to the PC. I want to simulate it and therefore need to see a terminal that will present the data being sent to the PC from the PIC during …

Jul 29, 2021 · I would like to simulate a small signal RF amplifier on VHF. Can LTSpice simulate RF and if so can anyone point me to a tutorial that shows the proper set-up for LTSpice? Thanks...

Jul 30, 2017 · I just generated a functional simulation model for a DPDT relay symbol I had previously downloaded (both attached). It includes an approximate 15ms open and close delay to simulate the …

Jul 17, 2025 · hi, I wanna know if it was possible to simulate in proteus 8 with adxl345 and arduino. I cant find library for adxl345 anywhere. if any1 know, pls share, thx

Jul 19, 2019 · Hello, I want to simulate a 3 phase YD1 (star Delta) transformer in LTSpice, but the output of secondary transformer( Delta SIde is not coming properly). Can please someone check where I …